maximum deviation
英 [ˈmæksɪməm ˌdiːviˈeɪʃn]
美 [ˈmæksɪməm ˌdiːviˈeɪʃn]
网络 最大偏差; 最大调制度; 最大偏移; 调制频偏; 最大频偏
双语例句
- According to multiindex characteristics of appraised design proposals, the rational weight coefficient among them is given by using the comprehensive appraisal value of maximum deviation and entropy.
在灰色综合隶属度评价方法基础上，按照离差最大化原理，提出了一种品种区域试验的新的确定权重的方法。 - The results of comparative measuring tests from an UV-VIS spectrophotometer and our self-developed instrument respectively indicate that the maximum deviation between them was 0.418%, the minimum 0.098%, and the mean 0.220%, which satisfied the accuracy request of amylose content measurement.
将其与TU1800紫外可见分光光度计进行技术性能和使用效果对比，测定的数据最大偏差为0.418%，最小偏差为0.098%，平均偏差为0.220%，完全能满足大米直链淀粉测定精度的要求。 - The mathematical model was verified in experiment with the method of indirect squeeze cast Archimedean spiral proof sample. And the experimental results show that the maximum deviation between the theoretical value and measured value is less than 8%.
采用间接挤压铸造阿基米德螺旋线试样的方法对该数学模型进行了实验验证，实验结果表明：理论计算值与实验测定值之间的最大偏差小于8%； - The advantage of this measure is that the optimum rational reparameterization's parametric speed satisfies that the maximum deviation from unity is the minimum in this family.
利用该方法求得的最优参数化在曲线的重新参数化曲线族中，参数速度偏离单位速度的最大值达到最小。 - It shows that the maximum deviation between the two calculation models is near to 7%, the influence of the real gas can not be neglected.
结果表明：在接近饱和的状态下，实际混合气体效应不可忽略，在HAT循环饱和过程参数范围内两者的最大偏差接近7%。 - The maximum deviation is 12% under large oscillation.
大振荡时，在计及定子瞬态和转速的变化时，ks和kD解析解的最大误差小于12%。 - In order to make the maximum deviation between the data points and minimum fitting plane this paper presents a new method for calculating Best Fit Plane, and gives strict theoretical proof.
为使数据点与拟合平面的最大偏差达到最小，提出一种求最佳平面的新方法，并给出严格的理论证明。 - Second, we develop a neighbor smoothing algorithm, which is based on the fact that the maximum deviation is minimum, to eliminate the small object in the image.
为了消除图像中的细小目标，提出了一种基于最大偏差最小的邻域平滑法。 - By using maximum deviation of project's evaluation value and maximum entropy principle, the model is established.
该方法利用了待评方案的离差最大化原则和最大熵原理，建立了防空信息战系统的灰色层次关联评价模型。 - Maximum Deviation and Entropy Method for Design Proposals Optimization
设计方案优选中的离差最大化及熵值法 - The maximum deviation is in within 1.0 percent by comparing obtained values of heat capacities with the literature values.
比热容的测量结果与文献标准值比较，最大偏差不超过1.0%，表明量热器具有较高的精度和稳定性。 - Hydraulic design of micro& irrigation lateral requires the calculation of the minimum pressure hole to decide the place of the maximum pressure hole, maximum deviation in micro-irrigation laterals and limit length.
毛管水力设计，需要计算最小压力孔号，判断最大压力孔位置以及毛管最大压力偏差和极限长度，虽然已提出解析公式，但有相当大的工作量。 - The results indicated that the average absolute deviation ad maximum deviation were 0.72% and 1.67%, respectively.
实验结果表明，测量的实验结果与文献值的平均偏差为0.72%，最大偏差为1.67%。 - The comparison result of this method with other laboratory determination shows that the maximum deviation is 6%.
对比结果显示，该方法与其他实验室测定结果的最大偏差为6%。 - The developmental process simulation system can be calculated the composition of gas and liquid, process parameters, as well as the size of equipment and structure. The maximum deviation between calculation value and real productive value is about l0%.
开发的流程模拟系统可计算气体、液体的组成和工艺参数，以及设备和结构的尺寸、其计算值与生产实际值最大偏差约10%。 - A qualitative explanation based on law of conservation of mass and energy theory of breaking and aggregating of bubble was made. An empirical correlation was presented on the base of experimental data, with average deviation of 6.3% and the maximum deviation of 20.8%.
并根据质量守恒定理和气泡聚并的能量理论对以上结论做出了定性的解释，另外对实验数据进行了回归分析得到气含率的实验关联式，平均相对偏差为6.3%，最大偏差为20.8%。 - Experiment shows that the maximum deviation of Z coordinates measured by this system and ordinary contacting coordinate measuring machine is 13 μ m.
经实验比较，本系统测量结果与接触式坐标测量机测量曲面点Z坐标极限偏差13μm。 - By correlating the experimental data, equations for calculating the pressure drop, packing factor, flooding gas velocity and gas phase overall height of a transfer unit were obtained. The calculated results were in conformity with the experimental data, which maximum deviation was 17%.
通过试验数据处理，得到了计算该填料层压降、填料因子、液泛气速和气相总传质单元高度的关联式，这些关联式的计算结果与实测结果吻合较好，其中最大偏差为（±17%）。 - Besides a comparison of the characteristic line, the normalized mean square root error, the normalized mean error, and the maximum deviation are calculated and discussed.
除了用单行数值比较法外，还计算了重组和数学模型之间的归一化均方根偏差、归一化平均偏差和最大偏差。 - Under the premise of meeting the function requirements, the tolerance design is guided by the maximum deviation of the elements.
通过计算机编程实现了各种规范操作，可以确定在满足功能要求前提下该要素的最大偏差，用来指导公差设计。 - The result shows that the error of average windward area is less than 1.38%, and the maximum deviation of repeatability is less than 0.03%. The accuracy of this system meets the requirement.
实验结果表明：平均迎风面积的最大误差小于1.38%，重复测量的最大偏差小于0.03%，测量精度符合并优于技术指标要求。 - For highly enriched uranium, the relationship between the coincidence neutron counting rate and the mass of the components is exponential, the maximum deviation of the fit mass is 12.16%, and the thickness of the components has become the greater impact factor.
而对于高浓铀，符合中子计数率与其质量近似成指数关系，拟合质量最大偏差为12.16%，且部件的厚度成为了更大的影响因素。 - The transient gas flow models were established and solved by fluid network theory. Compared to the conventional numerical methods ( implicit difference method and character line method), the maximum deviation was about 1 percent among the methods.
通过建立管道瞬态流动模型，首次采用流体网络理论对模型进行求解，并和传统的数值解法（隐式差分法和特征线法）进行对比，得到两者最大偏差约为1%。 - The test result shows that the maximum deviation value of all openings air volume is 6% compared with the calculated value, and is 9% compared with the CFD simulation. The design of air volume is met.
结果表明，各风口风量的测试值与设计计算值的最大偏差为6%，与CFD模拟结果的最大偏差为9%，满足风量的设计要求。 - Robust optimization method is an effective way to solve the uncertain problems, the maximum deviation between the result of which and the optimal result in all kinds of possible scenarios can be least.
鲁棒优化方法是解决不确定问题的有效方法，可使得到的解与各种可能情景下的最优解的最大偏差达到最小。